A Post-Storm Roof Inspection in California is the fastest way to separate cosmetic wear from real storm damage before it becomes a ceiling stain. We inspect shingles, flashing, skylights, and attic decking after wind, hail, or heavy rain, document everything with photos and moisture readings, and hand you a report your insurance adjuster can actually use. If you are searching for a roof inspection near me after a rough weather week, we cover the whole state.
A Post-Storm Roof Inspection in California is a top-to-bottom assessment of your roof system after wind, hail, or heavy rain, performed by a licensed roofing contractor rather than a salesperson. We walk the field, check every penetration, and test suspect areas with a moisture meter and infrared camera. Missing shingles, lifted flashing, granule loss, and hairline punctures all get photographed and logged. You get a written report with severity ratings, so you know what needs repair now, what can wait, and what your policy will likely cover.
California storms hit differently depending on where you live. Santa Ana winds tear at ridge caps in Palmdale and Moreno Valley, while atmospheric rivers push water sideways through stucco and window flashing in San Diego and Santa Rosa. After a big system rolls through, most homeowners wait for a ceiling stain before calling anyone. That is a mistake. Water travels along roofing underlayment and rafters long before it drips into a living space. An emergency roof inspection right after the storm catches the intrusion while the evidence is still fresh and the repair is still small.
Every inspection includes the full exterior and attic assessment, photo documentation, and a written report. Repairs are quoted separately, and you are never obligated to hire us for the work. Here is what you get when you book.
A licensed inspector walks the entire roof field, checking shingles, tiles, ridge caps, valleys, and every penetration. We photograph missing shingles, lifted flashing, and impact marks. On flat roofs we check seams, blisters, and ponding. This is the core of the inspection and takes 30 to 45 minutes on a typical home.
We enter the attic with a moisture meter and infrared camera, reading decking, rafters, and insulation. Elevated readings tell us where water is entering even when there is no visible stain below. We mark each wet reading on a roof diagram so you can see the pattern.
Every finding gets a close-up photo, a location note, and a severity rating from 1 to 5. We also note the brand and condition of your shingles, whether that is GAF, Owens Corning, CertainTeed, or another line. This documentation is what makes the report usable for a claim or a future repair bid.
You receive a PDF report within 24 hours with all photos, moisture readings, and a prioritized list: repair now, monitor, or replace. The report is formatted for insurance submission and includes dates and storm context. You can forward it to your adjuster as-is.
If the inspection finds damage, we quote the repair in the same visit. You get a line-item price for each recommended fix, with no bundled mystery charges. If you want a second opinion, the report stands alone and you can hire any licensed contractor.
You call (877) 299-0450 or book online. We ask three questions: storm date, roof type, and whether you have seen interior staining. That tells us whether to send a standard inspection crew or an emergency roof inspection team the same day. Most California addresses get a scheduled visit within 24 to 48 hours of the storm passing.
A licensed inspector walks the full field with a ladder and safety harness, checking ridge caps, field shingles, valleys, and every penetration. We photograph missing shingles, lifted flashing, and impact marks. On flat roofs we check for ponding and seam separation. This portion takes 30 to 45 minutes on a typical 2,000-square-foot ranch home.
We go inside the attic with a moisture meter and infrared camera, reading decking, rafters, and insulation for elevated moisture. We also check ceilings and skylight wells from below. This is where hidden flashing leaks and skylight leaks show up first, often days before a stain appears on the drywall. Expect 20 to 30 minutes for this step.
Every finding gets a photo, a location note, and a severity rating from 1 to 5. We mark wet readings on a roof diagram and note the brand and condition of your shingles, whether that is GAF, Owens Corning, CertainTeed, or an older discontinued line. This documentation is what makes the report usable for a claim or a future repair bid.
We email the written report within 24 hours and walk you through it by phone or on-site. You get a clear list: repair now, monitor, or replace. If you want us to handle the repair, we quote it in the same visit. If you want a second opinion, the report stands on its own. No obligation either way.
You call (877) 299-0450 or book online. We ask three questions: storm date, roof type, and whether you have seen interior staining. That tells us whether to send a standard inspection crew or an emergency roof inspection team the same day. Most California addresses get a scheduled visit within 24 to 48 hours of the storm passing.
Reads moisture content in decking, rafters, and insulation. Elevated readings reveal hidden intrusion before it shows as a ceiling stain.
Detects temperature differences caused by wet materials. We use it to scan attic decking and ceiling areas for moisture patterns invisible to the eye.
OSHA-compliant fall protection for steep-slope roof access. Every inspector wears a harness on any roof above six feet.
Used to carefully lift shingles and flashing edges to check for hidden water damage underneath, without causing new damage.
For temporary sealing of active leaks found during inspection. We use Henry Company sealant and roof cement for emergency patches.
A San Diego homeowner had a spreading ceiling stain after three days of rain. The roof looked fine from the ground, and two other contractors said the shingles needed replacement. The stain kept growing.
After: Our inspector found the leak at the skylight curb flashing, not the shingles. We rebuilt the curb with new membrane and sealant for $650. The ceiling dried out, and the stain stopped spreading within a week.
Book this service →
A windstorm tore 14 shingles off a Roseville roof and left the underlayment exposed. Rain was forecast in two days, and the homeowner could not get a roofer out for a week.
After: We tarped the exposed section the same day, then inspected the full roof. We replaced the missing shingles and resealed the ridge cap for $580. The repair matched the existing shingle color, and the roof passed a water test.
Book this service →
A commercial building in Stockton had standing water on its flat roof after a heavy rain. The property manager had been told the whole membrane needed replacement at a cost of $18,000.
After: Our inspection found two open seams and a clogged drain, not a failed membrane. We repaired the seams and cleared the drain for $1,200. The ponding stopped, and the membrane has years of life left.
Book this service →These are the four most common post-storm issues we find on California roofs, and what happens if you leave them alone.
Ask a pro →We inspect every flashing detail with a moisture meter and infrared camera, then reseal or rebuild the counter-flashing with new membrane and sealant. Most flashing repairs are completed in one visit and tested with water before we leave.
We replace missing shingles with matching profiles and reseal the field. If the underlayment is compromised, we replace that section before installing new shingles. On older roofs we source discontinued colors when possible to keep the repair invisible.
We inspect EPDM, TPO, and modified bitumen membranes for open seams and blisters, repair them, and restore drainage so water moves off the roof. We also clear clogged gutters and downspouts, which is often the root cause of the ponding.
We clear gutters and downspouts, reseal gutter seams, and check flow away from the foundation. Proper drainage is the cheapest leak prevention there is, and we include it in every post-storm inspection report.
Most post-storm roof inspections in California run $150 to $450 in 2026, depending on roof size, pitch, and whether you need a full insurance-ready report. A basic walk-and-photo inspection on a single-story ranch home is usually at the low end. Two-story homes, steep pitches, and tile roofs take longer and cost more. If you hire us for the repair, we credit the inspection fee toward the work.
A full post-storm inspection includes an exterior roof walk, an attic moisture check with a meter and infrared camera, photo documentation of every finding, and a written report with severity ratings. We check shingles, flashing, skylights, chimneys, valleys, and gutters. On flat roofs we check seams and ponding. You get a repair-now list, a monitor list, and claim-ready photos.
Get a roof inspection after every major storm, and a routine inspection every 18 to 24 months even in quiet weather. California roofs take a beating from UV, Santa Ana winds, and atmospheric rivers. An annual check catches clogged gutters and cracked sealant before they become leaks. If your roof is over 15 years old, move to once a year.
Yes. A trained inspector with a moisture meter and infrared camera can find storm damage that is invisible from the ground, including lifted flashing, hairline punctures, and wet decking. We document granule loss, creased shingles, and impact marks with close-up photos. That evidence is what supports a roof inspection for insurance claim, and it is why we recommend inspecting within two weeks of the storm.
We deliver post-storm roof inspection services in California across the entire state, from the Mexican border to the Oregon line. Our crews are positioned in major regions so we can respond within 24 to 48 hours after a storm system moves through. Whether you need an emergency roof inspection in San Diego or a routine post-storm check in Roseville, we schedule the closest available team to your address.
Palmdale sits in the Antelope Valley wind corridor, where Santa Ana events strip shingles and ridge caps. We inspect for wind uplift and document every missing shingle for your claim.
↗ 02 West CovinaWest Covina roofs take a beating from summer heat and winter wind. We check for thermal cracking in shingles and flashing, plus attic moisture after heavy rain.
↗ 03 ComptonCompton has a mix of older bungalows and newer construction. We inspect both with the same standard, checking flashing, skylights, and attic decking for hidden storm intrusion.
↗ 04 Garden GroveGarden Grove's flat and low-slope roofs pond after heavy rain. We inspect seams, drains, and membrane condition, and we clear clogged gutters that cause edge damage.
↗ 05 Laguna HillsLaguna Hills homes sit in the coastal fog belt, where salt air corrodes fasteners and flashing. We check every fastener and sealant joint after a storm.
↗ 06 San DiegoSan Diego's mix of historic bungalows and modern homes means every inspection is different. We trace hidden leaks from skylights and chimney flashing back to the source with moisture meters.
↗ 07 San MarcosSan Marcos gets wind-driven rain from the west that pushes water through stucco and window flashing. We inspect those details along with the roof field and attic.
↗ 08 Moreno ValleyMoreno Valley's inland heat and wind events crack shingles and lift ridge caps. We document granule loss and impact marks with close-up photos for insurance claims.
↗ 09 HemetHemet roofs face intense UV and seasonal wind. We check for sun damage that weakens shingles before storms, plus active leaks after rain.
↗ 10 CamarilloCamarillo's coastal exposure means salt air and wind. We inspect flashing, fasteners, and sealant joints that degrade faster here than inland.
↗ 11 StocktonStockton's Central Valley location brings hail and wind. We document impact damage and check flat roofs for ponding after heavy rain.
↗ 12 RosevilleRoseville sees Sacramento Valley wind and hail. We inspect ridge caps, valleys, and field shingles, and we replace missing shingles with matching profiles.
↗ 13 OaklandOakland's steep-pitch roofs and mature tree canopy mean debris and clogged gutters. We clear gutters and inspect for wind damage after every storm.
↗ 14 Santa RosaSanta Rosa's North Coast storms bring wind-driven rain. We inspect for water intrusion at flashing and skylights, and we check attic moisture thoroughly.
↗ 15 PleasantonPleasanton's tile roofs and complex valleys need careful inspection. We check valley flashing and dormers, which are the first places wind-driven rain finds a gap.
↗Storm damage gets worse with every rain. Call (877) 299-0450 and we will schedule your inspection within 24 to 48 hours. Licensed, insured, and statewide. If you have active water intrusion, tell us when you call and we will prioritize your address for same-day service.
Book Inspection (877) 299-0450 →Call (877) 299-0450 any hour, any day. A live dispatcher answers, takes your address, and sends the nearest crew. Most California metro calls get a technician on site within 60 to 90 minutes. You can also email [email protected] with photos of the leak.